Shenzhen Baiqiancheng Electronic Co.,Ltd
+86-755-86152095

Analysis of Common Defects in AOI Inspection

Feb 06, 2026

With the iteration of the high-end manufacturing field, the production quality of PCB directly determines the reliability of terminal equipment. The missed detection and misjudgment rate of traditional manual quality inspection exceeds 20%, which is difficult to adapt to high-precision production. The detection accuracy of AOI is up to 0.01mm, the misjudgment rate is ≤3%, and the efficiency is more than 20 times higher than that of manual work, realizing the standardization of quality inspection.

The following are the common defect types detected by AOI.

(I) Soldering Defects: Highest Proportion, Directly Affecting Circuit Conductivity

Soldering defects account for more than 60% of all defects detected by AOI, mostly occurring in the SMT process, caused by abnormal parameters such as solder paste dosage and soldering temperature. There are 4 common types:

  1. 1. Cold Solder Joint (False Solder Joint)
  2. It is characterized by insufficient contact between solder and pins/pads, caused by insufficient solder paste, temperature fluctuation, etc. For example: The cold solder joint of the automotive connector Pin is caused by abnormal furnace temperature, with prominent hidden dangers.
  3. 2. Bridging (Short Circuit)
  4. Adjacent pads and pins are connected by excess solder, caused by excessive solder paste, misplaced placement, etc.
  5. 3. Insufficient/Excessive Solder
  6. Insufficient solder affects connection strength, and excessive solder is prone to cause bridging, both related to solder paste printing. Optimizing the stencil and printing parameters can reduce the defect rate by more than 80%.
  7. 4. Tombstoning (Drawbridge Effect)
  8. One end of the chip component is lifted, caused by uneven heating of the pad, misplaced placement, etc.

(II) Circuit Defects: Affecting Signal Transmission, Prominent Hidden Dangers in High-Frequency Scenarios

Circuit defects account for about 20%, mostly occurring in the PCB circuit manufacturing process, with more obvious hidden dangers in high-frequency scenarios. There are 3 common types:

  • 1. Circuit Open Circuit/Break
  • There is a break in the circuit, caused by over-etching, too thin circuit, etc.
  • 2. Circuit Short Circuit
  • Unnecessary conduction between adjacent circuits, caused by insufficient etching, substrate contamination, etc.
  • 3. Circuit Notch/Burr
  • It affects the stability of circuit impedance, caused by etching and exposure. AOI can accurately identify it and support process optimization.

(III) Component Defects: Dual Impact of Placement and Incoming Materials, Prone to Cause Functional Failure

Component defects account for about 15%, mostly occurring in the placement process, and some are related to incoming materials. There are 3 common types:

  • 1. Missing/Wrong Component
  • Failure to place the corresponding component, or inconsistent model/polarity reversal, caused by placement machine failure, incoming material error, etc.
  • 2. Component Offset/Skew
  • Placement deviation exceeding the allowable range is prone to cause secondary defects. The adoption of AI vision-guided AOI can reduce the defect rate by more than 90%.
  • 3. Component Damage/Contamination
  • Caused by poor incoming materials, unclean environment, etc., affecting product performance.

(IV) Other Defects: Unignorable Hidden Dangers in Details

Other defects account for about 5%, including PCB scratches, pin coplanarity deviation, etc. Pin coplanarity deviation is a blind area of traditional 2D AOI, which requires 2D+3D equipment for identification.