(1) In order to obtain a stable feedback circuit, it is usually necessary to use small resistors or chokes outside the feedback circuit to provide buffering for capacitive loads.
(2) Because most of the radiation is generated by common-mode voltage and current, and because most of the electromagnetic interference in the environment is caused by common-mode problems, using balanced transmission and reception (differential mode) technology in analog circuits will have a good EMC effect and can reduce crosstalk. Balanced circuit (difference channel) driver will not use 0V reference system as the return current loop, so it can avoid large current loop, thus reducing RF radiation.
(3) Avoid using high impedance input or output which is very sensitive to electric field.
(4) Input and output filters should be placed at the connection of external cables. Due to the antenna effect, any wiring in the unshielded system needs to be filtered. In addition, digital signal processing or switching mode converter shielding system also needs filtering.
(5) EMC filters should be used, and all IC related filters should be connected to the local 0V reference plane. Like digital integrated circuits, the power and ground reference pins of analog integrated circuits need high quality RF decoupling. However, analog integrated circuits usually need low-frequency power decoupling, because the power supply noise rejection ratio (PSRR) of analog components hardly increases above 1kHz. RC or LC filtering is applied to the analog power line of each operational amplifier, comparator and data converter. The corner frequency of the power filter should compensate the PSRR corner frequency and skew of the device, so as to obtain the required PSRR in the whole working frequency range.
(6) In order to obtain a stable linear circuit, all connections must be protected by passive filters or other suppression methods (such as photoelectric isolation).
(7) EMC filters should be used, and all IC related filters should be connected to the local 0V reference plane.
(8) For high-speed analog signals, transmission line technology is necessary according to their connection length and the highest communication frequency. Even for low-frequency signals, the anti-jamming ability can be improved by using transmission line technology, but if there is no correctly matched transmission line, antenna effect will occur.
(9) Outside the feedback loop, do not use active circuits to filter or control EMC's RF bandwidth, but only use passive components (preferably RC circuits). The integral feedback method is effective only when the open-loop gain of the operational amplifier is greater than the closed-loop gain. At higher frequencies, the frequency response cannot be controlled by the integrating circuit.
(10) The integral feedback circuit usually needs a small resistor (about 560Ω) in series, and each integral capacitor is greater than 10PF.
(11) Some analog ics are particularly sensitive to RF fields, so it is usually necessary to use a small metal shielding box mounted on the PCB and connected to the ground plane of the PCB to shield such analog components. Please take care to ensure that the cooling belt is installed in place.
(12) The comparator must have hysteresis (positive feedback) to prevent wrong output conversion due to noise and interference and oscillation at the breakpoint. The speed of using the comparator shall not exceed the requirements (keeping the DV/dt within the required range and as low as possible).
Analog circuits cover almost the whole electronic field. The functional realization of any electronic circuit involves analog circuits. The design of analog circuits is usually more difficult than that of digital circuits, and the level of designers is also higher. This is one of the reasons why analog circuit system is more popular than digital circuit system.






