After the PCB is mounted or plug-in, it becomes a finished circuit board. The whole process is also called PCBA. However, how are the components mounted from the blank board to the finished board? First, according to the requirements of the BOM, after the appropriate components are equipped in the mall, they are sent to the factory for placement.
The steel mesh needs to be made according to the PCB soldering layer, and the hollow position of the steel mesh is exactly the same as the PCB row position. The purpose is to accurately apply the solder paste to the pads. After the stencil is completed, the solder paste is printed. In order to ensure the activity of the solder paste, the solder paste is added in small amounts and several times at a time to prevent the flux from volatilizing. In the printing process, there will be a total of six actions including PCB board feeding, track stop positioning, mark point centering, table rising, squeegee printing solder paste, and OCB landing. This cycle reciprocates and automatically prints. This is one of the advanced PCBA processes. Important process steps. Printed PCB boards need to go through SPI inspection, which is also an important process of PCBA. The solder paste thickness tester uses optical images to check the offset, area, volume, height and short circuit of the solder paste, and screen out the bad printing in time. PCB.







