The reasonable layout of electronic components on PCB boards is an extremely important step in reducing welding defects! Components should avoid areas with extremely large deflection values and high internal stress as much as possible, and the layout should be as uniform as possible
Forming plate edge milling plate
Placing components too close to the edge of the board may cause the solder pads of the components to be milled off during forming and milling. Generally, the distance between the solder pads and the edge should be greater than 0.2mm, otherwise the solder pads of the board edge components will be milled off and cannot be soldered during assembly.
Forming plate edge V-CUT
If the board edge is assembled with V-CUT, the components need to be further away from the board edge, because the V-CUT knife passes through the middle of the board, and the distance between the components and the V-CUT board edge is generally at least 0.4mm. Otherwise, the V-CUT knife will damage the solder pads, causing the components to be unable to be soldered.
Component interference equipment
The layout of components during design is too close to the edge of the board, which may interfere with the operation of automatic assembly equipment during component assembly, such as wave soldering or reflow soldering machine equipment.
Equipment damage to components
The closer the component is to the edge of the board, the greater the potential interference of the component on the assembly equipment. For example, components such as large electrolytic capacitors should be placed further away from the edge of the circuit board than other components because electrolytic capacitor components are relatively high.
Damaged components on the sub board
After the product assembly is completed, the assembled product needs to be separated from the board. During separation, components that are too close to the edge may be damaged, which may be intermittent and difficult to detect and debug.






