Shenzhen Baiqiancheng Electronic Co.,Ltd
+86-755-86152095

Temperature Cycling and Fatigue in Electronics

Jan 02, 2020

The majority of electronic failures occur due to thermally induced stresses and strains caused by excessive differences in coefficients of thermal expansion (CTE) across materials. 


CTE mismatches occur in both 1st and 2nd level interconnects in electronics assemblies. 1st level interconnects connect the die to a substrate. This substrate can be underfilled so there are both global and local CTE mismatches to consider. 2nd level interconnects connect the substrate, or package, to the printed circuit board (PCB). This would be considered a “board level” CTE mismatch. Several stress and strain mitigation techniques exist including the use of conformal coating.


The excessive difference in coefficients of thermal expansion between the components and the printed board cause a large enough strain in solder and embedded copper structures to induce a fatigue failure mode. This paper discusses the solder fatigue failure mechanism and the associated PTH (plated through hole) fatigue failure. The solder fatigue failure is more complicated due to the many solder materials and different solder shapes. Figure 1 shows an example of a solder fatigue failure in a cross section of a ball grid array (BGA) solder ball with the corresponding finite element model. The predicted location of maximum strain corresponds to the same location of solder fatigue crack initiation.


The majority of failures in electronics are caused by thermomechanical loads and solder fatigue is the major failure mechanism. The CTE mismatch between the board, component and attach materials creates stresses in the solder and the plating material. Experimental data for solder fatigue predictions and basic models can be used to predict solder fatigue for surface mount components. Board designers can change component placement and board laminate material to alleviate fatigue since component level design changes are usually not an option. The board laminate design also affects PTH reliability. The board designer influences PTH reliability by modifying drill diameters, laminate material, and plating parameters. Solder and PTH fatigue are just two of the many effects of thermomechanical loads but they can be predicted and prevented.