As a core carrier for SMT placement, the tension stability of stencils directly determines the soldering accuracy and finished product yield of PCBA. Industry data shows that insufficient or uneven tension will cause defects such as stencil deformation, insufficient solder paste printing, and bridging, increasing the defective soldering rate by more than 30%. Especially in the production of high-density PCBA, a slight tension deviation may cause micron-level printing errors, affecting the reliability of subsequent processes. Therefore, full-life-cycle tension control has become a core prerequisite for precise PCBA manufacturing.
At present, the industry has formed a standardized control process covering the entire chain of production, use and maintenance. On the production side, through the "pre-stretching - stabilization - secondary stretching" process, the tension is accurately controlled at 30-40N/cm with a distribution deviation ≤±3N/cm, and the flatness of the stencil surface is ensured to meet the standard through double detection; during use, multi-point detection of on-line stencils is required, re-inspection is conducted every 5,000 printed pieces, and stencils with tension lower than 25N/cm are immediately taken off the production line for processing; special brackets and shockproof packaging are adopted for storage and transportation to avoid deformation risks.
Technological innovation is promoting the upgrading of control towards intelligence and long-term effectiveness. Intelligent detection equipment collects data through sensors and generates thermal maps, and improves detection efficiency and accuracy with AI algorithms; the application of 304L high-elastic stainless steel mesh cloth reduces the tension attenuation rate of stencils by 40% and significantly extends the service life; the pre-tension strengthening process and digital twin system further solve the deformation problem of ultra-fine aperture stencils and optimize tension uniformity.
Standards such as IPC-A-610 and GB/T 14677 clearly specify the qualified tension range and detection requirements, and enterprises in high-end fields further control the deviation within ±2N/cm. Standardized control not only reduces the defect rate but also saves 100,000 to 150,000 yuan per production line annually.
Industry experts point out that with the deepening of the high-density trend of PCBA, the requirements for tension control accuracy will continue to increase. In the future, the integration of intelligent equipment, new materials and standardized systems will promote the transformation of control from "passive detection" to "active prevention", laying a solid foundation for the high-quality development of the industry.





