In the field of electronics manufacturing, flux is an essential auxiliary material in the PCBA soldering process. Rosin, as the main component of traditional flux, effectively removes metal surface oxides and enhances the wettability of solder. However, after soldering, if rosin residues are not thoroughly removed, they can lead to a decrease in the insulation performance of the circuit board, increased corrosion risks, and even affect subsequent testing and product reliability. Therefore, rosin cleaning is a crucial step in the post-processing of PCBA.
I. Traditional Solvent Cleaner (Alcohol)
The traditional cleaning method involves using a cotton swab dipped in alcohol (with a concentration of over 75%) to wipe the areas with rosin residues. After the rosin is dissolved, it is wiped clean with a soft cloth. Due to alcohol's low flash point, flammability, and potential harm to human health, this cleaning method has been replaced by new eco-friendly aqueous cleaning agents.
II. Circuit Board Cleaner
Solvent-based Circuit Board Cleaner: Circuit board cleaners such as isopropyl alcohol have strong dissolving power and fast evaporation rates. However, proper ventilation is required, and contact with ignition sources should be avoided.
Eco-friendly Aqueous Circuit Board Cleaner: The main component of eco-friendly aqueous circuit board cleaners is water. These cleaners use surfactants to break down rosin residues. When using aqueous circuit board cleaners, it is essential to rinse thoroughly to ensure all residues are removed.
III. Ultrasonic Cleaner
Place the soldered circuit board into an ultrasonic cleaner and use eco-friendly aqueous cleaning agents. The combination of the physical force from the ultrasonic cleaner and the chemical action of the aqueous cleaning agents effectively removes rosin residues.






