Recently, we have received complaints from customers about the pads falling off and parts dropping from PCBA, irregular pads and hole rings falling off, which seems to be caused by the pads and hole rings being worn off by the etching machine during the production process of the PCB board. Through line analysis experiments, it was found that it was not the etching machine that was stuck, because there are a series of processes in PCB production, and each link has inspection and control. After etching and before solder mask, 100% must be inspected by AOI scanning. Only after confirmation can it be sent to solder mask production. After the shape is formed, it needs to pass the continuity test, and only after passing the test can it be sent to the next process for inspection, packaging and patching.
During the PCBA processing process, it is necessary to pay attention to the amount of flux used (too much or too little), and then the purity and density of the flux. If the purity of the tin wire or tin bar does not meet the requirements during PCBA welding, it will also cause the PCBA pads to fall off. When welding products, it is necessary to carefully check whether the solder paste fully meets the customer's requirements. For example, the purity and lead content of the solder paste need to be checked and confirmed before it can be used on the machine. During use, it is necessary to observe whether the solder paste has abnormal changes. If there is any abnormality, it is necessary to stop using it immediately and notify the process department for analysis and processing.
After checking the PCB board and a series of problems that may arise during the production process, the suspicious points are finally placed at the patch and post-weld repair. Through the control of the patch, plug-in furnace and furnace temperature, when the furnace temperature is normal, the first stage of preheating temperature is controlled at 110℃±2℃, the second stage of preheating temperature is controlled at 120℃±2℃, the third stage of preheating temperature is controlled at 130℃±2℃, and the fourth stage of preheating temperature is controlled between 260-270℃. The speed of the first stage of wave soldering is 26.5 meters/hour, and the speed of the second stage of wave soldering is controlled within 35 meters/hour. No PCBA pads are found to fall off. At the same time, we followed up on other customers' boards and found no PCBA pad falling off. Then, we analyzed the repair parts and found that the soldering iron temperature was too high, which caused the PCBA pad to fall off. The soldering iron temperature was too high and stayed on the welded parts for too long, which would cause the PCBA pad to fall off. When the soldering iron temperature reached above 500℃, the repair parts would have pad falling off. After analysis, we adjusted the soldering iron temperature to between 350-370 degrees Celsius and tested again. No pad falling off was found in the follow-up.






