Shenzhen Baiqiancheng Electronic Co.,Ltd
+86-755-86152095

How to solder with soldering iron

Dec 20, 2019

Preparation for soldering with soldering iron:

- Turn on your soldering iron. Set desired temperature on soldering iron. Dampen the sponge in the stand (sponge should be damp, not soaking wet). Turn on smoke absorber if you have one.

 

- Clean the soldering area and dirty components. All components must be clean and free from oxidation, grease, and other contamination. Solder will not stick to dirty component or dirty area on printed circuit board.

 

- Tip of soldering iron must be clean as well. Clean the tip of soldering iron using the damp sponge.

 

- Before soldering, the tip of soldering iron should be “tinned” or, in other words, coated with solder. Apply some solder to the tip of soldering iron, then wipe on the damp sponge.

 

- If you are soldering static sensitive components, wear anti-static protection (ESD) like a wrist strap.

 

Soldering with soldering iron

1) Insert component into metalized hole of circuit board.

 

2) Take soldering iron from stand and hold it as a pen.

 

3) Apply a tip of soldering iron to the joint and hold for few seconds. Make sure it touches both the track on circuit board and the component lead.

 

4) Continue heating and apply some solder to the joint, not the soldering iron. Heating one part but not the other will result in poorly formed joints. Solder should melt and flow smoothly onto the track and component lead to form volcano shape. The most common problems with soldering are adding too much or not enough solder.

 

5) It only takes couple seconds to make a perfect joint. The heating period depends on the temperature of your soldering iron and size of the joint. First remove the solder, then remove the soldering iron while keeping the joint sill. Do not move circuit board for a few seconds to allow the joint to cool.

 

6) Inspect soldered joints. Adjacent components may be bridged together or the joint may need additional solder for good electrical continuity.