1.Making of test materials. The test data of the flying probe is simple. Usually, the correctness of the network analysis is the key. Secondly, the number of test points in the same network is optimized, which has little effect on the test speed. The materials of production fixture data is high requirements. Usually, the cam software is easy to miss the selection point and multiple selection points. The production speed of multilayer board is much slower. At present, a lot of manufacturers purchase special production test software.As consequences, the production test can be faster, no manual points, and the maintenance will be much faster.
2.Test fixture production.The test fixture manufacturing is also a cumbersome process. From the discharge, the post-hole inspection, the winding, the needle placement, and the installation and commissioning, all the care and patience are required to produce a high-level fixture. Among them, it is very important to check the accuracy of drilling. When encountering dense small holes, drilling off one hole may cause the entire fixture to be dismantled and reworked. This is the key to optimizing the production of fixtures. Secondly, it is possible to integrate multiple drilling data, especially the data integration when drilling conductive glue, thereby reducing the complexity and cumbersomeness of drilling operators, reducing the error summary, and optimizing the testing to improve the software. In addition, improving the engineering skills and technicians will also optimize the whole fixtures.
Shenzhen Baiqiancheng equipped with experienced engineers are sure to help you make a satisfactory test fixture.
