Shenzhen Baiqiancheng Electronic Co.,Ltd
+86-755-86152095

Quality Control in SMT (6) - Tombstoning

Oct 18, 2023

The following reasons may cause this quality issue.

1. An insufficient reflow profile

Using a low temperature & a short preheating time can greatly increase the possibility that the solder pastes will not melt simultaneously at both pads. An unbalanced surface tension results in "tombstoning."

A preheating temperature of 150+10°C and a time of 60-90 seconds is recommended

2. Unreasonably designed pads

There is a difference in size and shape between the two pads or one of the pads is connected to the ground wire or the pad area on one side is too large, and the heat capacity at both ends of the pad is uneven.

3. Thick Solder paste

A thick stencil or inadequate printing parameters can easily lead to thick solder paste. Reflow occurs when molten solder paste lifts the components. A tombstoning can occur when the forces acting on the pads are unbalanced.

4. Components offset

When the solder paste melts, the surface tension pulls the component back into place, correcting the offset generated during placement. It's called "adaptive." The components stand up when the offset is severe, causing a "tombstone" effect. Because the solder in contact with the component melts first. Therefore, the solder paste stickiness between the two pads is different.

5. Weighing of the component

When a component is light, it is more likely to experience "tombstoning" due to the fact that, for small components, the component nearly floats on the liquid solder paste during reflow. Differential wetting forces on pads can cause components to rotate. Thus, if possible, use components with larger sizes and weights when selecting components.