Application of PCB cutting equipment
With the increasing requirements of PCB circuit boards in consumer electronics and automotive electronics such as mobile phones, the cutting edge has no dust, no burrs, no deformation, and will not affect edge components. It has become the mainstream requirement. The traditional processing mode milling cutter, Cutting, punching, sawing and other modes will affect the PCB circuit board to varying degrees.
The non-contact processing mode of laser cutting equipment does not generate stress and dust, and the processing gap is particularly small. These advantages make this processing mode stand out and are more and more favored by major manufacturers. However, the PCB laser cutting machine also has its fatal shortcomings. The processing efficiency is low. Compared with the traditional cutting and milling, the processing speed has become its short board.
In the PCB laser cutting machine processing mode, the high-energy beam emitted by the laser enters the galvanometer through the beam expander, and the lens is deflected by clicking, and the introduction field lens is focused into a smaller light spot to scan back and forth on the surface of the PCB circuit board, ablating layer by layer. , forming a cut.
In order to realize full automation of production, improve production efficiency and improve product quality, Shenzhen Baiqiancheng Electronics Co., Ltd. abandoned the traditional method of sub-board and introduced PCB laser cutting equipment, which greatly improved production efficiency.
