Shenzhen Baiqiancheng Electronic Co.,Ltd
+86-755-86152095

Common Solder Paste Issues in SMT Chip Processing Plants

Mar 15, 2024

Using a small scraper to remove the solder paste from the misprinted board may cause some problems. A generally feasible approach is to immerse the misprinted board in a compatible solvent, such as water with some additive, and then use a soft bristled brush to remove the small tin beads from the board. I would rather soak and wash repeatedly than vigorously dry or scrape. The longer the operator waits to clean the misprint after solder paste printing, the more difficult it is to remove the solder paste. The misprinted board should be immediately placed in a soaked solvent after discovering the problem, as the solder paste is easy to remove before drying.

 

Avoid wiping with a cloth strip to prevent solder paste and other contaminants from applying to the surface of the board. After soaking, washing with a gentle spray can often help remove unwanted tin drafts. At the same time, SMT surface mount processing plants also recommend using hot air drying. If a horizontal template cleaning machine is used, the surface to be cleaned should face downwards to allow the solder paste to fall off the board.

 

Methods for preventing solder paste defects in SMT surface mount processing on PCBA:

During the printing process, wipe the template according to a certain pattern between the printing cycles. Ensure that the template is located on the solder pad, not on the solder mask layer, to ensure a clean solder paste printing process. Online and real-time solder paste inspection and pre reflow inspection after component installation are both helpful process steps in reducing process defects before welding occurs.

 

For fine pitch templates, if the thin template cross-section is bent and causes damage between pins, it can cause solder paste to deposit between the pins, resulting in printing defects and/or short circuits. Low viscosity solder paste may also cause printing defects. For example, a high operating temperature or scraper speed of a printing machine can reduce the viscosity of solder paste during use, causing printing defects and bridging due to excessive deposition of solder paste.